Is a network channel the same as a port?

Douglas Beier asked a question: Is a network channel the same as a port?
Asked By: Douglas Beier
Date created: Sat, Aug 21, 2021 4:20 AM
Date updated: Sun, Jul 24, 2022 9:28 AM


Video answer: Introduction to two-port networks

Introduction to two-port networks

Top best answers to the question «Is a network channel the same as a port»

A channel group is a collection of Ethernet interfaces on a single switch. A port channel interface is a virtual interface that serves a corresponding channel group and connects to a compatible interface on another switch to form a port channel.

Video answer: 17. find the 'z' and 'y' parameters in dependent source in two port network

17. find the 'z' and 'y' parameters in dependent source in two port network

10 other answers

Yes, they are all same. In IOS-XR world, they call it bundle-ether. Port-channel can be of L2 or L3 depending on how you configure it. Thanks, Madhu

channel group with the same channel number as the port channel and takes the default Layer 2 configuration, as well as the compatibility configuration (see the “Compatibility Checks” section on page 5-2). Note The port channel is operationally up when at least one of the member ports is up and is in the channeling state.

A Virtual Port Channel (vPC) is an enhancement to MEC that allows for the same sort of functionality — building a port channel across two switches — without the need for Stackwise or VSS. Both Stackwise and VSS go far beyond just port channels: They actually combine the control and management planes of the member switches effectively turning them into one logical entity.

To access the router’s web-based control panel, type in your wireless router’s IP address (most commonly or After logging in to the router, find the wireless settings and change the selected channel. If your router has an auto channel selection feature, you can disable it and manually choose your preferred channel.

A network channel is a configuration item in WebLogic that defines the communication endpoint of a network connection. This usually includes the protocol used, the IP, and port which WebLogic has to use for the network listener.

Therefore, to provide load-balancing, packets from different IP addresses use different ports in the channel, but packets from the same IP address use the same port in the channel. With destination-IP-address-based forwarding, when packets are forwarded to an EtherChannel, they are distributed across the ports in the EtherChannel based on the destination-IP address of the incoming packet.

EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers. An EtherChannel can be created from between two and eight active Fast, Gigabit or 10 ...

A trunk port allows you to send all those signals for each switch or router across a single trunk link. In contrast to an access port, a trunk port must use tagging in order to allow signals to get to the correct endpoint. Trunk ports typically offer higher bandwidth and lower latency than access ports.

FC network card: also commonly called fiber channel network card, stand for Fiber Channel HBA. The transmission protocol is a Fibre Channel protocol, which is typically connected to a Fiber Channel switch via a fiber optic cable. The interface type is divided into optical port and electrical port.

Term “Port-channel” is the name of this virtual interface in cisco IOS platforms. In the Nexus switches, the port-channel term is used for technology and the individual interface. Once we have configured an Etherchannel we make all you changes on the Port Channel interface and these will be automatically applied to all the individual interfaces within the Etherchannel.

Your Answer

Video answer: Two port network-numericals [two port parameters, interconnections & relation between parameters]

Two port network-numericals [two port parameters, interconnections & relation between parameters]